Today, we are working with our Barbed Wire Dispenser machine. We are going to set it up. There is no barbed wire on it yet. These are all fresh rolls. What we have to do is make sure they are laying down properly so it untwists in a certain way so it goes on the…
Blog
How to use fence hangers to hold up chain link before tying
Today I want to talk a little bit about our hangers that we use. It’s a pipe, 1 3/8 inches, cold roll rod that’s bent. We use these temporary hangers when we are running out the chain link fence, whether rolling it out on the ground or coming out of our Installink machine, we are…
Lobo Post Puller gets at difficult fence posts in ditch
Today we are working at the airport and we have an existing fence we have to pull out and relocate it. We actually are going to put up a new fence. Where the location of the old fence is that we are pulling out is in the bottom of a ditch. it’s pretty hard to…
Easy Twist Ties meet ASTM Specifications
Today I want to talk about the ASTM specifications and how our Easy Twist tool and Easy Twist Ties meet the ASTM standard. ASTM has a term of “three full twists.” This is where the confusion starts. Three full twists – ASTM’s definition for that is at F552. In there, it states it is “1…
Comparing Rhino’s GPD-40 and GPD-45 post drivers
Today, we are going to show a comparison of the Rhino GPD-40 and GPD-45 post drivers. We are going to pound an 8 foot post four feet into the ground, actually a little more than four feet. This is showing tough conditions. The conditions are clay and rock and we are going to see how…